INSTALLATION:
Receiver LMR-404 (Refer to Fig. 2)
z
Disconnect main power before installation.
z
Connect DC wire and load (lamp) to receiver block terminal OUT.
z
Connect RGB wires into receiver block terminal RGB, making sure correct colour are fitted into the terminal. Connect
main power on.
OPERATION :
Transmitter LMT-1008 (Refer to Fig. 1)
z
Main “ON” button:
Turns on the main load.
z
Main “OFF” button:
Turns off the main load.
z
RGB “ON” button:
Turns on the RGB LEDs
z
RGB “OFF” button:
Turns off the RGB LEDs
z
“FLASH & FADE” button.
FLASH mode: Changes color in approximately 4 seconds
FADE mode: Gradually fading color changes in approximately 12 seconds.
z
“STROBE” button:
For selecting the desired color. (12 selectable colors)
z
“DELAY OFF” button: Turns off automatically after 10 seconds.
z
“Security mode”:
Randomly turns on & off the main load.
To activate, hold both RGB “ON & OFF” button for 3 seconds.
To deactivate, simply press any button on the transmitter.
！
Will only operate for the main load.
！
Main load connected to LMR-404 receiver will light “ON” for the first time main power “ON”.
※
REMARK
※
z
RGB mode (FLASH /FADE /STROBE) will be memorized at the last turned “OFF” mode, so next time switching
“ON” will stay at the last memorized mode.
HOW TO LINK CODE:
z
To start, program transmitter with receiver.
z
Connect power to receiver
z
Bring transmitter near receiver, push once the self learning button on receiver, this will enter learning mode.
While in learning mode, RGB light connected to receiver will flash in RED to indicate ready for programming.
z
Then on transmitter press main “ON” button once, RGB light connected to receiver will flash in BLUE to indicate
programming is confirmed and completed.
！
During leaning mode if within 10 seconds no signal is detected it will automatically return to stand-by
mode.
TO CHANGE OR DELETE CODE :
z
Bring transmitter near receiver, push once the self learning button on receiver, this will enter learning / deleting mode.
While in learning / deleting mode, RGB light connected to receiver will flash in RED to indicate ready for deleting.
z
Then on transmitter press main “OFF” button once, RGB light connected to receiver will flash in BLUE to indicate
programmed code is deleted.
TO DELETE ALL CODE :
z
On receiver hold down the self learning button on receiver for 6 seconds, this will enter learning / deleting mode.
While in learning / deleting mode, RGB light connected to receiver will flash in RED to indicate ready for deleting.
z
Then press again the self learning button, RGB light connected to receiver will flash in BLUE twice to indicate all code is
deleted.
