LITE-CHECK VERIFIER TRAILER INSPECTION SYSTEM
VERIFIER Trailer Interface and Tablet Setup
The following steps should be taken to ensure proper setup of the Lite-Check VERIFIER Trailer
Interface.
1. Mount the unit securely
2. Connect the incoming air supply with at least 120 PSI from the compressor through a filtered air
regulator set to
NO LESS
than 120 PSI
3. Connect the Emergency and Service air lines to the front of the VERIFIER
Warning:
The Trailer-Interface has self-calibrating air pressure transducers -
IT IS
IMPERATIVE THAT THE TESTER ONLY EXPERIENCE ATMOSPHERIC PRESSURE
DURING POWER-UP AND REBOOT
. This can be achieved by connecting the air lines
to the front of the tester, and the regulated supply air must also be connected..
DO
NOT CONNECT THE GLADHANDS TO A TRAILER WHEN STARTING THE
TRAILER-INTERFACE
. Ensure that there are
NO
air circuits active when the
VERIFIER Trailer Interface is reset.
4. Connect the VERIFIER Trailer Interface Tester to a 12 Volt, 20 Amp power supply or 12V battery.
Warning:
A 12 volt battery charger cannot be used to power the system. Applied power must be
clean (filtered and regulated) and capable of supplying 20 Amps.
5. Press the Power Button to turn the tester on. The green LED next to the power button will
illuminate when the unit is on.
6. Turn on the Tablet
7. When the 1010 displays ”
WAITING FOR TABLET
” then open the
Lite-Check DOT app
on the
tablet.
8. The
Bluetooth
icon should be visible in the upper left corner of the tablet and the LCD screen
should show ”
TABLET CONNECTED
”. If this attempt is not successful, close the app and try
again. If a connection still cannot be established, perform the pairing procedure
(see Appendix
A)
.
Reminders
•
Do not use a battery charger while the VERIFIER Trailer Interface is in use. Battery chargers are
not regulated and may cause damage to the ABS ECU or the tester.
•
The VERIFIER Trailer Interface
will not operate properly below 11.5 volts
•
120 PSI
regulated air input
is required for proper air operation
8
