LITE-CHECK INSPECTOR 920
Page: 17 of 36
The sending lamp will light up when the button on the remote control is pressed
Power Supply
The tester is designed for negative ground vehicles (black-negative, red-positive). In
case of reversed battery leads on the power cable, the tester will not operate.
Power Supply Set Up:
Attach the battery cable clamps (or ring terminals) to a 12Vdc automotive battery, or a
regulated power supply (such as the LITE-CHECK 311R).
Black battery cable to negative
–
Red battery cable to positive
+
Turn the power switch located on the back panel of the tester on for operation.
Low Battery Messages
NOTE:
The tester will not work properly if the battery is not charged to a full 12+volts.
The tester will not operate and will possibly lock up if the power is below 10.5 volts.
Notes:
Replace (4) AA batteries if the sending lamp does not illuminate
Remove the batteries using the pull strap inside the case.
Do not pry them
out.
If remote controls need to be keyed to different testers, contact LITE-CHECK
for assistance
The tester antenna must be fully exposed for good test reception