Lister Petter alpha Series, Operator'S Handbook Manual

Page: 12 / 36

12
alpha series lWa/lWX genset operators' handbook
Generator kVA •
Generator Power Factor •
Generator Load (kVAr) •
Generator Load (kWh, kVAh, kVArh) •
Generator Phase Sequence •
Mains Voltage (ph-N) •
Mains Voltage (ph-ph) •
Mains Frequency •
Events Log •
Not all parameters are available on all
of the control modules.
2.4 eVent log
Press the left or right scroll button to
gain access. Pressing the down
button on this display will move to the
previous event, the event log entry at
position 1 being the most recent. On
moving from the instrumentation to
the event log the unit will display the
most recent entry. A number in the
bottom left indicates the event log entry
currently displayed.
The number of event log entries varies
on control modules. When the event
log is displayed the icon in the alarm
icon area indicates the alarm type at
that position of the event log. The
hours run at the time of the alarm
shows in the instrumentation area. The
bottom right icon indicates the current
mode as normal.
Example of Auxiliary Input Shutdown
Alarm (see Figure 2.4). Note display
may vary depending on control
module.
Controls
stop / reset
This button places the module into its Stop/Reset mode. This will clear any alarm
conditions for which the triggering criteria have been removed. If the engine is
running and the module is in Stop mode, the module will automatically instruct
the changeover device to unload the generator (' Close generator ' becomes
inactive (if used)). The fuel supply de-energises and the engine comes to a
standstill. Should a
remote start signal
be present while operating in this
mode, a remote start will not occur.
Figure 2.4 Example of Auxiliary Input Shutdown Alarm