Operation
Grinding machine SBM-XL 1000/1500 G2S2-60
33
5.4 Turning on the machine
Before turning on the machine, the following conditions must be checked:
Running direction of the grinding belts and abrasive belts correspond to
the manufacturer's specifications.
Function readiness of the connected exhaust system is ensured.
Acceptance of the workpieces at the output side of the machine is
ensured.
The SBM-G and SBM-S grinding units can be turned on independently of
each other. Thus for each work cycle the surfaces of the workpiece can be
ground and/or the edges rounded.
Place the main switch 13 on the back of the machine into the "On"
position.
Set the key switch 18 to the »On« position.
The power supply for the drives and the touch screen is turned on.
Make sure that all malfunctions are corrected.
Make sure that both »EMERGENCY STOP« buttons, 12 and 23, are
activated and a possible EMERGENCY STOP is acknowledged with the
20 button.
The »Start system« button 17 is illuminated.
Make sure that the exhaust system selection switch is set to »AUTO«.
Press the »Start system« button 17.
The grinding units and the exhaust system are turned on depending
on the previous operating mode.
Before grinding can begin, the following pre-requisites must be met:
The sheet thickness of the workpiece is measured and set on the
machine (see 5.5).
Feed is set (see 5.6).