Lissmac MULTICUT 605 SG, Operating Manual

Page: 57 / 107

57/107
8. MAINTENANCE
8.1. Service
WARNING
Cut hazard from rotating objects
Rotating objects can cut, crush or sever limbs on contact.

Maintenance and repair may only be performed with the machine switched off

Maintenance and repair may only be performed by trained personnel
 The machine must be secured against accidental startup
Cleaning
To protect the painted surfaces, no aggressive cleaning agents may be used.
High-pressure cleaners may not be used on engine and control components.
Replacement parts Only use genuine replacement parts from the manufacturer.
Material
See: 4.1 Consumables
Before each use daily weekly monthly
Conduct a visual inspection for obvious damage and defects.

Thoroughly clean the floor saw (depending on the application).

Check engine oil and transmission oil level

Change engine oil and transmission oil with respective filters every 6 Months or 250 operating hours
Check air filter cartridge

Replace air filter cartridge every 6 Months, or if required
Replace hydraulic oil and filter Initially after 100 then every 500 operating hours
Grease at grease points

Check safety features

Change Transaxle Oil and Oil filter Initially after 80 then every 400 operating hours
Check hydraulic lines and fittings

Check v-belt tension (initially after 2h)

Bolted connections
Check and tighten all bolted connections after 20 operating hours
(see 8.9 Torque values for screw connections)
These stated qualities apply to the standard use of the machine in average climatic conditions.
For extremely heavy-duty use under extreme climatic conditions, other specifications may be required.