Lissmac MULTICUT 605 SG, Operating Manual

Page: 23 / 107

23/107
4. COMISSIONING
4.1. Consumables
Diesel
Only use Diesel fuel according to EN 590 / ASTM D 975-09a 1-D S15 or 2-D S15
with a Sulfur content of <15 mg/kg. So-called Ultra Low Sulfur Diesel (ULSD).
When using other fuels, the emission levels change and the warranty expires.
Engine Oil
Only use HATZ-approved engine oil. Use at least quality grade ACEA E6. We recommend SAE 10W-40.
The use of lower qualities will half the maintenance intervals and the warranty may be voided.
Dispose of old engine oil properly with your disposal company in an environmentally conscious manner.
Observe the engine manufacturer's operating instructions, enclosed with each machine.
Pay particular attention to the safety and maintenance instructions.
Antifreeze
Use only antifreeze approved by HATZ. Use release grade H50. The use of lower qualities will halve the
maintenance intervals and the warranty may be voided.
Lubricant Only use quality grease on the grease nipple. The manufacturer uses "Energrease LS2 BP".
(Lithium-based multi-purpose grease of NLGI grade 2 according to DIN 51818/NLGI GC - LB grade 2)
Hydraulic oil The hydraulic fluid used must be of HVLP (High Volume Low Pressure) quality (according to DIN 51524-3 /
ISO 6743/4) in the ISO viscosity class 68.
Transmission fluid Only use the following transmission fluid type:
Option G: SAE 90 Agip Blasia SX 220
Option SG: Total SYN FE 75W-90
Water The water pressure in the supply line must not exceed 5 bar.If necessary, use pressure reducer.
These specifications refer to the usual operational and ambient conditions.
Other specifications may be required for use under extreme climatic conditions.
Observe the engine manufacturer's operating instructions, enclosed with each machine.
Pay particular attention to the safety and maintenance instructions.
S≤15 mg/kg