Lissmac Compactcut 900, Operating Manual, Page: 45 / 56

45/56
6.6. Troubleshooting table
The combustion motor must be turned off before any maintenance or repair work!
Measures must be taken, so that an accidental start-up by others is not possible!
Maintenance and service works may only be carried out by qualified personnel!
Error Cause Remedy
Low cutting performance Saw blade is dull Replace saw blade
too little cooling water Clean the water sieve or rinse the water
supply with pressure max. 5 bar
Motor does not perform the full power Refer to the operating manual of the
combustion motor
Incorrect saw blade direction of rotation Check saw blade direction of rotation
Floor saw does not start Fuel tank empty Refill fuel
Fuel filter contaminated Remove and clean fuel filter
Battery voltage too weak Check batter voltage and charge if
necessary
Control lever direction of movement in
wrong position Put control lever direction of movement in
centre position
Saw blade does not immerse Throttle valve closed Open throttle valve and lower again
NOTICE
Check the following points if you experience cutting problems:
 Saw blade dull or defective?

Too little water to cool the saw blade?

Saw blade selection correct?

Full power or rotation speed from the motor?