DMR
DIGITAL
TWO
WAY
RADIO
DMR
DIGITAL
TWO
WAY
RADIO
can transmit or receive.
Indicate red light while transmitting a signal.
Indicate green light while receiving a signal
Receiving and Answering group call
If want to receive the group call, the transceiver must set in this group. The
steps following below
1. LED indicates green light.
2. When using your transceiver, hold the transceiver in a vertical position
with the microphone 1 to 2 inches (2.5 to 5cm) away from the lips. If
active the “CH Free Indication Tone”, when the transmitting partner
release the PTT key, you will hear a short indication tone, this tell you
the channel is free now, and waiting for your answer.
3. Press PTT to answer. LED indicates red light.
4. When the tone of waiting answering is finished, users can talk to
microphone clearly.
5. Release PTT key to receive
6. If there is not any signal transmitting activity in the pre-set time, the call
will stop.
Receiving and Answering single call
Single Call is transmit in a single transceiver to another single transceiver;
there are two types of single call.
The first type
: check before call
The second type
: directly call
When receiving signal, the LED indicates green. One transceiver can only
set one type, the first type or the second type. The steps following below:
1. LED indicates green.
2. When using your transceiver, hold the transceiver in a vertical position
with the microphone 1 to 2 inches (2.5 to 5cm) away from the lips. If
active the “CH Free Indication Tone”, when the transmitting partner
release the PTT key, you will hear a short indication tone, this tell you
the channel is free now, and waiting for your answer.
3. Press PTT to answer. LED indicates red light.
4. Transmit the ‘Talk Permit Tone’ (if active), then talk to microphone
clearly.
5. Release PTT key to receive
6. If there is not any signal transmitting activity in the pre-set time, the call
will stop.
7. You will hear a short tone.
Receive All Call
All Call is a single transceiver to call all the users in a same channel, it is
used to issue important message.
When you receiving All Call, the steps following below:
1. Alert a tone, the LED indicates green.
2. If there is not any transmitting activity in the pre-set time, the All Call
will stop. If active the “CH Free Indication Tone”
Then when the calling party release PTT, you will hear a short tone, that
indicates the channel can use now. You cannot answer the All Call.
Note: When receiving the All Call, if you transfer to another channel, then
your transceiver will stop receiving this All Call. During All Call, you can not
use any pre-programmed keys, till the All Call is finished.
Start one type of Transmitting Call
You can use the following types to select a channel, users ID or group ID:
z
Channel Knob
z
Pre-programmed side button
Type one: Use Channel Knob
Start group call
If want to start group call, the transceiver must set in this group. The steps
following below:
1. Turn the channel knob, use the activated ID to select channel.