DMR
DIGITAL
TWO
WAY
RADIO
DMR
DIGITAL
TWO
WAY
RADIO
While press and hold MONI key, rotate Power
Supply Switch / Volume Adjuster to adjust
volume of transceiver.
Note
：
The Monitor key will be set at Side button PF1 or PF2 via software
programming.
Selecting Channels
Rotate the channels selector to select the
channels you desired. When your transceiver
receives the signals, the speaker will sound.
Please note this radios has two zones,
there is 16channels in Zone1 and another 16channels in Zone2.
Note
：
·When in VOX mode, you don’t need to press PTT key and speak into the
microphone.
·When the battery voltage is too low, the transmission will stop and the
speaker utter Low Battery Alarm. (See Page---)
Functions Instructions
Functions Instruction
LED indicator
The LED indicator indicates the transceiver working status.
Red – Indicates transceiver is transmitting now.
Green—Indicates transceiver is switching on or receiving unencrypted call
or signal, or it is checking the aerial sports now.
Alert Tone
Alert Tone indicates the transceivers status, or indicates the transceivers
receive the signal data response.
Continuous Tone
: Alert Monotonous tone. Transceivers will alert
continuously till stop.
Periodic Tone
: According to the set time of duration in the transceiver, it
will alert the periodic tone. Tone is self start, stop and repeat.
Repeating Tone
: The self-repeating tone, it will be stopped by users.
Momentary Tone
: Only alert momentary one time, the time set by users
via software.
Call (PTT) Key
The 32 channels in the transceiver all can be set as digital channel.
1. When in transmitting, press PTT key to transmit signal. Release PTT to
receive. When you press PTT, it will active microphone.
2. When do not transmit PTT key use to initiate a new call. According to
programming, if ‘Talk Permit Tone’ is active, wait till the tone is over.
3. When in the process of transmitting, if your transceiver is active “CH
Free Indication Tone” function (this will be pre-programmed), then
when your partner is releasing the PTT key, you will hear a short tone
that suggest you this channel is free, and waiting for your answer.
4. If the transmitting is stopped (Like transceiver receive the emergency
call), you will still listen the “CH Free Indication Tone”. You can stop all
the tones of transceiver to turn off the ‘CH Free Indication Tone’.
5. You can turn the knob to transfer the digital channel.
Receiving and Transmitting
Select Zone
One zone is one group of channels. The transceiver can support two
zones; there is 16channels in each zone.
1. Press pre-programmed zone button.
2. You will hear a positive tone, that indicates the transceiver already
transfers from Zone1 to Zone2; or you will hear a negative tone, that
indicates the transceiver already transfer from Zone2 to Zone1.
After programming the transceiver channel, Members ID, Zones ID, you
can turn the channel knob to select channel, users ID or Zones ID.
Receiving and answering transceiver call
After programming the transceiver channel, Members ID, Zones ID, you