Pulse Output Device
17
Get the latest PDF manual:
https://www.lcmeter.com/resources/technical/manuals
Mobile/online version of this manual:
https://www.lcmeter.com/manuals
Installing the POD
POD Extension Kits
If a POD Extension Kit is necessary, it must be installed prior to installation of the POD. See
POD Extension Kit Installation
.
Follow these steps to install the POD onto a flowmeter:
1. Verify that the proper POD Model was
obtained by comparing the driver tang on
the POD to the driver tang on the
packing gland that was removed in Step
5 of the
Retrofit
Installations
section
above. There are two types of packing
gland/POD driver tangs: blade type and
fork type. Blade type packing glands
must be replaced with blade type PODs.
Fork type packing glands must be
replaced with fork type PODs.
2. Determine the desired orientation of the
conduit hub. The hub can be positioned
in one of eight possible orientations as
shown in the figure to the right.
3. Position the O-Ring over the bottom of
the POD as shown to the right.
4. Align the fork style or blade style driver
with the drive mechanism in the meter
and guide the POD into the opening in
the meter cover. When properly aligned,
the POD will go in until its mounting
flange abuts the meter cover.
5. Rotate the POD to the desired
orientation and thread in the mounting
18
