Rev: 08.18.21
Page 31
CCD-0004099
NOTE:
On alternate versions of the Lippert 3000 series patio rail kit, there will
NOT
be two rear and front
bungees. An alternate version of the Lippert 3000 Series will have a J-bolt (Fig. 86A) located at both
side patio railing front bases (Fig. 87A). Pull the yellow lanyard (Fig. 86B) and turn the J-bolt a quarter
turn (Fig. 86C). Lower the side patio rails until it clicks in the J-bolt, locking the patio rail into position.
The J-bolt also holds the side rail panel down and in place when the yellow lanyard is pulled out and
turned a quarter turn and the patio railing is folded down into the stowed position. The bungee cords
located at the front of the patio rails now serves the same purpose.
Fig. 84
Fig. 85
A
B
C
A
A
4.
Located towards the top of the ramp door, release the driver's side front panel bottom leg (Fig. 84A) from
the keeper (Fig. 84B) by pushing the compression latch lever (Fig. 84C) towards the trailer, slide the leg
out of the keeper and release the lever.
NOTE:
Alternate versions of the Lippert 3000 series will have a spring plunger (Fig. 85A). Turn the lever
(Fig. 85B) towards the trailer, and release the driver's side patio rail leg.
Fig. 86
Fig. 87
A
B
C
A
B
