Rev: 12.13.2018
Page 3
CD-0002211
Installation
1.
Locate an area on the unit’s roof to mount the external cellular antenna (Fig. 1B). The area should be
relatively flat and be located within 10 feet of the cellular gateway (Fig. 1C) mounting location. Two
small coax wires (Fig. 1A) will need to be run between the cellular antenna and the cellular gateway.
2.
Position the antenna for mounting. The antenna should sit completely flat against the surface. Trace an
outline along the outer lip of the antenna.
3.
Cross cut the rubber roof (Fig. 2A) orange lines. The cuts should be 1
1/4”
long in each direction. Peel
the corners of the rubber roof back and drill a 1” hole (Fig. 2B, blue area) in the center of the cuts. This
is where the cables will pass from inside the unit to the cellular antenna.
NOTE:
Make sure that are no wires, pipes, etc., behind the drilling area before drilling.
Fig. 2
Fig. 1
B
A
A
C
12V DC/DC
Power Supply
2.4 GHz WiFi
Antennae
B
A
