8
Running your locomotive with the FlyerChief remote
Slide the TRANSFORMER/REMOTE switch to the REMOTE position.
Refer to Figure 1 on page 5 for the location of this switch.
With track power turned off, place your locomotive on the track
.
Power up the track to 18 volts (AC or DC) and move the remote power
switch to ON.
When the locomotive is powered up, it will beep until it syncs with the
remote. When the locomotive is synced up with the remote, the locomotive start-up
sounds will begin to play.
When in remote mode and powered up on the track, the
locomotive will continue to beep until it is synced up with its
remote. If the locomotive beeps during operation, be sure that
fresh batteries are installed properly in the remote and the
TRANSFORMER/REMOTE switch is in the REMOTE position.
Move ‘em out!
Use your remote to run your train. You can adjust the speed in for-
ward or reverse, blow the whistle, sound the bell, or trigger an announcement. Refer to
page 7 for complete details.
Turn off the power supply when you are done running your trains.
Switch off your remote control to conserve the batteries.
Remote operations
3
4
1
5
2
Note!
