Replacing your locomotive’s LEDs and lamps
Y
our locomotives are illuminated by several LEDs and lamps. During the course of normal
operations, they may require replacement.
We recommend that you have the LED and lamp replacemenst done at an authorized
Lionel Service Center. See the Lionel Service section on page 40 for more information.
Replacing the traction tires
Y
our powered A-unit locomotive is equipped with traction tires (Lionel part no. 620-8815-206)
to increase the tractive effort of your locomotive set and allow it to pull more cars at once.
During the course of normal operations, the traction tires may become worn out. To
replace the traction tires, remove the side frame screws from the underside of the trucks and
lift away the side frame. Remove the worn tire, then slip the replacement around the wheel.
Reposition the side frame on the truck and secure it with the two screws.
3
Maintaining and servicing your locomotive
Note!
Note!
Note!
Adjusting the smoke output
Y
our locomotives feature an improved smoke unit with variable smoke output. In the
TrainMaster Command Control environment, you may select low, medium, or high smoke
output using your CAB-1 Remote Controller. Your locomotives are shipped from the factory in
the medium smoke output setting.
To adjust the smoke output, bring the locomotive set to a stop, press
AUX1,
AUX2,
9
, then press
L
for low smoke,
M
for medium smoke, or
H
for high smoke. Press
AUX2
again to complete the
setting. See page 15 for the location of these buttons on the CAB-1 Remote Controller.
Your locomotive will remember its new setting until you change it again.
It may take up to a minute for the smoke unit to heat up or cool down to the new setting.
In the conventional environment, smoke output is always at the medium level. Smoke
output is not variable in the conventional environment.
Adjusting the variable smoke unit output using the
L
,
M
, or
H
buttons will also effect the
locomotives speed step/momentum setting (see page 14). After changing the smoke unit
output, simply reset the speed step/momentum to your preferred setting by pressing the
L
,
M
,
or
H
button once again.
