Copyright © 2016 Lintest Systems, LLC – All rights reserved 09/17/2016
PiCapture SD1 Specifications
PiCapture SD1
Compatibility
Raspberry Pi 1 A+,B+
Requires 40 pin GPIO connector
Raspberry Pi 2
Raspberry Pi 3
Physical Dimensions
65mm x 56.5mm
HAT form factor
Interface connectors
40 pin GPIO connector
Pass-through header is provided
CSI-2 MIPI camera
connector
Power Requirements
5V @ 250 mA
Supplied by Raspberry Pi
Supported Video
Formats
Standard Definition
Interlaced NTSC/PAL
De-interlaced and resampled to 640x480
Video Inputs
Composite
Up to 3 selectable composite sources
S-Video
YPbPr Component
Input Connectors
3 RCA/Phono
Used for composite or component inputs
1 Mini-DIN S-Video
Shared with RCA connectors 1 and 2
Status Indicators
Red “ACTIVE” LED
“Camera active” indicator (same as Raspberry Pi camera)
Green “RUN” LED
PiCapture Ready indicator
Blue “READY” LED
Video Active indicator
Yellow “PGM” LED
Programming / PiVideo Control Active Indicator
4 Green “FORMAT” LEDs
PiCapture Video Processor source type / status
Video Output Format
640 x 480
Configuration Jumpers
UART Select (2x2)
Remove to disconnect from serial port
I2C Select (3x2)
Select I2C port, or remove to disconnect from both I2C
ports
Included Accessories
CSI-2 MIPI interface cable
Mounting hardware
Spacers and screws for securing the PiCapture board
Software
PiVideo control software
Used to manage the PiCapture video processor
