OPERATION
When you have made all the required connections, switch on the mains
supply. Flashing bars will be shown on the back panel display for
approximately 5 seconds. During this time no audio will be issued.
When the display changes to show the standby symbol (see table below),
the speaker is ready to receive an audio signal.
Whenever the Majik 126 speaker is disconnected from the mains
supply and then reconnected, wait until the standby symbol appears
on the display before playing a disc.
Operating modes
Key to symbols
Parameters
The Majik 126 speaker is equipped with eight adjustable parameters (see
next page) that enable you to alter its performance to suit your taste.
Note:
The parameters can only be adjusted when the Majik 126 speaker is not in
standby mode.
A few seconds after the last key press the display
changes to
Adjusting the Parameters
To select the parameter you wish to adjust:
•
Hold
FEATURE
•
Repeatedly press
UP
or
DOWN
until the letter for the desired parameter
appears.
•
Release
FEATURE
.
•
Repeatedly press
UP
or
DOWN
to change the setting.
To restore the default settings:
•
Disconnect the
Majik 126
speaker from the mains supply and wait for the
display to go blank.
•
While holding
FEATURE
reconnect the mains supply.
•
Continue to hold
FEATURE
until the display shows
A few seconds after releasing
FEATURE
the display changes to
SYMBOL
MODE
MEANING
Standby
The unit is waiting for an audio signal
In this mode the unit consumes minimal
power.
On
The unit is fully powered-up
The unit will enter this mode as soon as it
receives an audio signal.
Thermal Standby The unit has overheated
During very demanding, sustained use the
unit will go into Thermal Standby mode in
order to allow itself to cool down. When in
this mode the unit will not produce any
sound. The unit will return to On mode
when its temperature has dropped to its
operating level.
HP OUT
AL OUT
A IN
-
H
-
4
Majik 126
