
Controller Series E1031/2031/4031 V3
NTI AG
Installation: E1031/E2031/E4031 V3 series / 28.07.2010
Page 14/17
Error codes
In the Error State the controller displays the error code by the 7-segment display:
Code
Description
E0001
Missing or invalid parameter tree
E0002
Missing or invalid application
E0003
Controller type not supported
E0004
MT command interface not available
E0005
Timer watchdog error
E0006
Trap class A error
E0007
Trap class B error
E0008
No master found for slave motor.
E0009
No external sensor defined
E000A
External sensor not allowed on channel D
E000B
The application software needs an MT Electronics
E000C
Noise Dead Band is not supported on this device revision (must be set to 0mm)
E0010
DCLV Power Too Low
E0011
DCLV Power Too High
E0012
DCLV Signal Too Low
E0013
DCLV Signal Too High
E0014
Electronic Fault
E0015
HW Error Internal 12V missing
E0101
Drive A Too Hot Calculated
E0102
Drive A Too Hot Sensor
E0103
Drive A Following Error
E0104
Drive A Slider Missing
E0106
Drive A Init Failed
E0107
Drive A Drive Type Mismatch
E0108
Drive A Curve Error
E0109
Drive A: Board Over Current
E010A
Drive A: Board Over Temperature
E010B
Drive A: AGND or 5VDC Fuse Blown
E0201
Drive B Too Hot Calculated
E0202
Drive B Too Hot Sensor
E0203
Drive B Following Error
E0204
Drive B Slider Missing
E0206
Drive B Init Failed
E0207
Drive B Drive Type Mismatch
E0208
Drive B Curve Error
E0209
Drive B: Board Over Current
E020A
Drive B: Board Over Temperature
E020B
Drive B: AGND or 5VDC Fuse Blown
E0301
Drive C Too Hot Calculated
E0302
Drive C Too Hot Sensor
E0303
Drive C Following Error
E0304
Drive C Slider Missing
E0306
Drive C Init Failed
E0307
Drive C Drive Type Mismatch
E0308
Drive C Curve Error
E0309
Drive C: Board Over Current
E030A
Drive C: Board Over Temperature
E030B
Drive C: AGND or 5VDC Fuse Blown
E0401
Drive D Too Hot Calculated
E0402
Drive D Too Hot Sensor
E0403
Drive D Following Error
E0404
Drive D Slider Missing
E0406
Drive D Init Failed
E0407
Drive D Drive Type Mismatch
E0408
Drive D Curve Error