9
Chapter 5: Using the Configuration Utility
Network
PowerLine AV Ethernet Adapter
Network
The
Network
screen lists the devices on your HomePlug AV powerline network, all devices with the same
Network Password. (If you have any HomePlug 1.1 or older devices, they will not be detected.)
Status. Displayed here is the MAC address of the Adapter currently accessed by your computer.
The table describes the Adapters on your powerline network.
Device Location. Click once to select this field. Click again to edit it. Enter the location of the Adapter.
MAC Address. Displayed here is the MAC address of the Adapter. L stands for local; this indicates that the Adapter
is physically connected to the computer you are using. R stands for remote; this indicates that the Adapter is
physically connected to another computer or other network device.
Data Rate (Mbps). Displayed here is the transmission speed of the Adapter, except for the one currently accessed
by your computer.
To detect all devices on the powerline network, click the
Scan Network
button.
To access a specific Adapter, select it on the list and click the
Connect
button.
To exit the Configuration Utility, click
Exit
.
Figure 5-2: Network Screen
Figure 5-3: Network Screen with Named Locations
NOTE:
If you are adding a new Adapter to a pre-existing powerline network with a unique
Network Password (not the default), then the new Adapter may not be detected. Refer to the
“Security - Device Password” section for instructions.
Summary of Contents for PLE200 - PowerLine AV EN Adapter Bridge
Page 1: ...Model No WIRED PLE200 User Guide Ethernet Adapter PowerLine AV ...
Page 30: ...24 Appendix E Regulatory Information PowerLine AV Ethernet Adapter ...
Page 31: ...25 Appendix E Regulatory Information PowerLine AV Ethernet Adapter ...
Page 32: ...26 Appendix E Regulatory Information PowerLine AV Ethernet Adapter ...
