LinkAYL LK-CP63 Series, Quick Start Manual

Page: 3 / 5

www.linkayl.com Copyright © Linkayl Technology Limited
LK-CP63X Control Panel
¢
Manual control
05 06
¢
Control mode
— A er power on all the LEDs light for 1 second and turn off, the power indicator LED
normally on
— Press reset bu on, all the LEDs light for 1 second and turn off, reset successfully
— L2 will be explosion-flashing a er controller receives fire signal
— External manual switch is equivalent to controller panel switch
— The maximum running me of the motor is 5 minutes
.
.
£
Group control
— Controller has inching mode and con nued-run mode which is default
— In the con nued-run mode, press UP or DOWN bu on less than 1.5 seconds, the motor
will run con nuously, press UP or DOWN bu on more than 1.5 seconds, the motor will
stop a er running a very short moment
— In the inching mode, press UP or DOWN bu on less than 1.5 seconds, the motor will stop
a er running a very short moment, press UP or DOWN bu on more than 1.5 seconds,
the motor will run con nuously
—
Only the manual bu ons on the panel, manual switch, remote control and cascade signal
have inching mode
—
Keep pressing both of UP and STOP bu on on the controller for 5 seconds, LEDs flash 3
mes and turn off it's inching mode for the controller, repeat the opera on the controller
turns to con nued-run mode
— By default, L1 is normally on, the rest LEDs are off as group control status
— Press UP bu on, the windows open, LED turns on, turns off a er 5 seconds
— Press DOWN bu on, the windows close, LED turns on, turns off a er 5 seconds
— Press STOP bu on, ,the motors stop, LED turns on, LED turns off a er 1 second
£
Channel control
— Press channel selec on keys the corresponding LED lights, channel selected
—
Press the channel selec on bu on again or no opera on on controller thin 10 seconds,
LED turns off, channel unselected
—
In the process of opening/closing the current window, you can select another channel(s)
to drive the window
.
¢
Remote control
— The controller encodes by 433MHz learning code, can store 10 sets of transmission codes
— The controller defaults to mul ple channel, single channel controler has the same way as
mul ple channel one
.
£
Matching code
—
Power the controller on, choose the channel(s) you want to set, can be set to any
combina on of channel 1-4
— Pressing STOP bu on on controller for 5 seconds
— LED flashes 3 mes and turns off
— Choose the channel you want to set on the remote
— Press UP within 15 seconds
— LED flashes 3 mes and turns off
— Code matched successfully
.
£
Clearing single code
— Power the controller on
— Keep pressing STOP key on the controller for 5S
—
LED flashes 3 mes and turns off
— Press DOWN bu on on the remote within 15 seconds
—
LED flashes 3 mes and turns off
— Code cleared successfully
.
£
Clearing all codes
— Power controller on
— Pressing STOP /DOWN bu on on the controller for 5 seconds
— LEDs flash 3 mes and turn off
— All the codes will be deleted a er this opera on