CONNECT AND OPERATE
1
. Connect a source such as a Blu-Ray Player, game console, A/V Receiver,
Cable or Satellite Receiver, etc. to the HDMI input on the Transmitting unit.
2. Connect a display such as an HDTV or HD Projector to the HDMI output
on the Receiving unit.
3. Connect a single Category 5e/6 up to 164ft/50m to the output of the
Transmitting unit, and the other end to the input of the Receiving unit.
4. For power, plug both the Transmitting unit and Receiving unit with the
included power supplies.
5. Power on each device in the same sequence (receiver and transmitter
will already be powered when either unit is plugged in.)
At this point the display connected should display the source signal
connected to the extender set. If no signal is being displayed, check the
receiver EQ swithcer. If a display is having difficulty receiving a signal, see
EDID section and perform EDID learning or access the display's menu and
adjust the resolution (lowest to highest until signal is displayed). A 24 Hz
vertical refresh rate may work better than 60 Hz or higher. Use the source
remote at the receiver emitter to test IR functionality. If the IR remote
function is not responding, check the emitters to ensure they are placed
correctly and are plugged into the correct IR jacks on the Extender set
receiving and transmitting units.
Wideband IR(30KHz---60KHz) introduction
