LL-RLP-20 Datasheet
www.link-labs.com
Information contained in this document is subject to change without notification
9
REGULATORY COMPLIANCE INFORMATION
U.S./CANADA REGULATORY COMPLIANCE INFORMATION
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a
separation distance of 20cm or more should be maintained between the antenna of this device
and persons during operation. To ensure compliance, operation at closer than this distance is
not recommended.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
U.S./CANADA OEM LABELING REQUIREMENTS FOR END-PRODUCT
The module is labeled with its own FCC ID and IC Certification Number. The FCC ID and IC
certification numbers are not visible when the module is installed inside another device, as such
the end device into which the module is installed must display a label referring to the enclosed
module. The final end product must be labeled in a visible area with the following:
“Contains Transmitter Module FCC ID: 2ACT6LLRLP20”
“Contains Transmitter Module IC: 12201A-LLRLP20”
or
“Contains FCC ID: 2ACT6LLRLP20”
“Contains IC: 12201A-LLRLP20”
The OEM of the module must only use the approved antenna(s) listed above, which have been
certified with this module.
OEM END PRODUCT USER MANUAL STATEMENTS
The OEM integrator should not provide information to the end user regarding how to install or
remove this RF module or change RF Related parameters in the user manual of the end
product.
Other use manual statements may apply.
