Linhai 2005 ATV 260, Service Manual

Page: 50 / 341

CHAPTER 3A ENGINE
260/ 300 cc ATV SERVICE MANUAL07.0
CHAPTER 3 ENGINE PAGE. 3A- 13
inspecting the oil level.
ENGINE OIL REPLACEMENT
1. Start the engine and let it warm up for several
minutes .
2. Turn off the engine and place an oil pan under
the engine.
3. Remove :
z
Oil filer plug
z
Drain plug
c
z
Compression spring
d
z
Oil strainer
e
z
O-ring
z
Drain the crankcase of its oil.
4. Install:
z
O-ring
c
NEW
z
Compression spring
d
z
Oil strainer
e
z
Drain plug
f
z
Oil filer plug
NOTE :
Check the drain plug O-ring. If damaged,
replace it with a new one.
5. Fill:
z
Crankcase
Oil quantity:
1.4L
6. Check:
z
Engine oil level
Refer to "ENGINE OIL LEVEL INSPECTION"
section
ENGINE OIL PRESSURE INSPECTION
Inspection steps:
z
Slightly loosen the oil check bolt
c
z
Start the engine and keep it idling until the oil
begins to seep from the oil check bolt. If no oil
comes out after one minute, turn the engine off
so it will not seize.
z
Check oil passages and oil pump for dam age
or leakage.
z
Start the engine after solving the problem (s),
and recheck the oil pressure.
z
Tighten the oil check bolt to specification.