3
Mullion Mounting
The reader can be mounted on a wall or any suitable fl at surface. The Mullion-mounted BluePass Reader can be installed as a new
device, or replace an existing one. Depending on the mounting location, new mounting screws may be necessary. These instructions
assume no previous mounting hardware exists.
To properly mount the BluePass Reader, perform the following steps:
1. Identify a suitable location for mounting with proper power
supply.
2. Mark location on wall for mounting screws approximately 3
inches apart with the power supply wires in center.
3. Drill two holes.
4. Install wall anchors to support mounting screws.
5. Feed power cable through mounting bracket’s center
opening.
6. Place mounting bracket on wall, aligning screw mounting
positions with wall anchors.
7. Insert two (2) screws.
8. Connect Reader wires to corresponding Wiegand wiring on
panel.
9. Connect the power supply wires to BluePass Reader.
Note:
Ensure power supply is not energized until all wires
are properly connected and terminated.
10. Feed excess cable into wall.
11. Mount BluePass Reader into upper and lower mounting
stubs.
Once completed, the BluePass LED ring will illuminate amber.
The administrator establishes the proper online credentials
profi les that enables the reader to function properly. After
the profi les are created and the initial scan is complete, the
illumination ring will change to blue.
ADA Mounting Height Requirements
ADA has certain height and reach requirements to allow
access for persons in wheelchairs.
• Keypads should be mounted so that the top of the number
touchpad is no more than 48” above the fi nished fl oor with no
obstructions in locations where wheelchair access is available only
from the front.
• Keypads should be mounted so that the top of the number
touchpad is no more than 54” above the fi nished fl oor with
no obstructions in locations where the wheelchair has
sideways access.
SCREW
MOUNTING
POSITIONS
UPPER
MOUNTING
STUBS
LOWER
MOUNTING
STUB
BluePass Reader Mullion Mounting Bracket