233190 X3 Linear LLC
33
May 2013
Interpreting the System Status LED on the Cabinet Door
LED State
Meaning
OFF
System is down
BLINKING RED
System is starting up or shutting down, but the controller
does not see a gateway to a network
ON RED
System is up, but the controller does not see a gateway
to a network
BLINKING BLUE
System is starting up or shutting down and the controller
sees a gateway to the network
ON BLUE
System is up and the controller sees a gateway to the
network
Interpreting Beeps
# of Beeps
Meaning
Shutting Down:
Two beeps
Most operating tasks have been completed and the
file system is about to be un-mounted. After waiting
a few seconds, you can remove power.
Powering Up:
One beep
Startup is complete and you can log into the system.
This may take several minutes.
Resetting System IP and Login Factory Defaults (via the hardware)
Three beeps
The IP and login factory defaults have been reset
via the REVERT button (see page 38).
Resetting System Configuration Factory Defaults (via the software)
Three beeps
The system configuration factory defaults have
been reset via the Initmode page in the UI, and the
system is about to reboot.
Note
: Unlike the controller, Network
Nodes do not beep at any time. If
readers are connected, you may hear beeps from the readers as they
power up.
