LT8330
15
8330fa
For more information
www.linear.com/LT8330
Based on the preceding equations, the user should choose
the inductors having sufficient saturation and RMS cur-
rent ratings.
SEPIC Converter: Output Diode Selection
To maximize efficiency, a fast switching diode with a low
forward drop and low reverse leakage is desirable. The
average forward current in normal operation is equal to
the output current.
It is recommended that the peak repetitive reverse voltage
rating V
RRM
is higher than V
OUT
+ V
IN(MAX)
by a safety
margin (a 10V safety margin is usually sufficient).
The power dissipated by the diode is:
P
D
= I
O(MAX)
•
V
D
where V
D
is diode’s forward voltage drop, and the diode
junction temperature is:
T
J
= T
A
+ P
D
•
R
θ
JA
The R
θ
JA
used in this equation normally includes the R
θ
JC
for the device, plus the thermal resistance from the board,
to the ambient temperature in the enclosure. T
J
must not
exceed the diode maximum junction temperature rating.
SEPIC Converter: Output and Input Capacitor Selection
The selections of the output and input capacitors of the
SEPIC converter are similar to those of the boost converter.
SEPIC Converter: Selecting the DC Coupling Capacitor
The DC voltage rating of the DC coupling capacitor (C
DC
,
as shown in Figure 5) should be larger than the maximum
input voltage:
V
CDC
> V
IN(MAX)
C
DC
has nearly a rectangular current waveform. During
the switch off-time, the current through C
DC
is I
IN
, while
approximately –I
O
flows during the on-time. The RMS
rating of the coupling capacitor is determined by the fol-
lowing equation:
I
RMS(CDC)
>
I
O(MAX)
•
V
OUT
+
V
D
V
IN(MIN)
A low ESR and ESL, X5R or X7R ceramic capacitor works
well for C
DC
.
INVERTING CONVERTER APPLICATIONS
The LT8330 can be configured as a dual-inductor inverting
topology, as shown in Figure 7. The V
OUT
to V
IN
ratio is:
V
OUT
−
V
D
V
IN
= −
D
1
−
D
in continuous conduction mode (CCM).
applicaTions inForMaTion
Inverting Converter: Switch Duty Cycle and Frequency
For an inverting converter operating in CCM, the duty
cycle of the main switch can be calculated based on the
negative output voltage (V
OUT
) and the input voltage (V
IN
).
The maximum duty cycle (D
MAX
) occurs when the converter
has the minimum input voltage:
D
MAX
=
V
OUT
−
V
D
V
OUT
−
V
D
−
V
IN(MIN)
Conversely, the minimum duty cycle (D
MIN
) occurs when
the converter operates at the maximum input voltage :
D
MIN
=
V
OUT
−
V
D
V
OUT
−
V
D
−
V
IN(MAX)
Figure 7. A Simplified Inverting Converter
C
DC
V
IN
C
IN
L1
D1
C
OUT
V
OUT
8330 F07
+
GND
LT8330
SW
L2
+
–
+ –
+
