36
DO934SBS
EN
· The appliance may not be used with an extension lead or a multiple socket.
· Follow the instructions below to prevent contamination of food:
· Keeping the door open for long periods may cause the temperature in the compartments of
the appliance to rise considerably.
· Clean the surfaces that could come into contact with food regularly. Keep the condensation
channel and drainage hole at the back of the appliance clean.
· Store raw meat and fish in suitable containers in the refrigerator so that they do not come
into contact with or drip onto other food.
· If the appliance is left empty for longer periods, it should be turned off, defrosted and
cleaned. Allow it dry and leave the door ajar to prevent mould from growing in the appliance.
WARNING! Never place this appliance on or in the neighbourhood of a gas or electric fire
or in a place where it could come into contact with a heat source. There are flammable
materials located on the back of the appliance.
Pay attention to the symbol ‘Fire risk – flammable materials’ located on the back of the
appliance.
INSTALLATION
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth.
· Avoid placing the cabinet in a narrow recess or near any leave source, direct sunlight, or moisture.
· Let air circulate freely around the cabinet. Keep the rear of the refrigerator 7,5 cm away from the wall.
· Select a place with a strong, level floor.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly on the
evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
· The appliance must be grounded. The manufacturer is not responsible for damages that may occur as
a result of usage without grounding.
· For uneven surfaces, front feet can be aligned.
· After installation, leave the freezer for 3 hours before turning it on. This way the refrigerant can settle.
