User Manual
English
2
Pre-Installation Remarks
Important!
Before starting the installation, please ensure that all devices are powered off.
The EDID preset timings stored in the extender are the following:
720x400@70Hz; 640x480@60/72/75Hz; 800x600@60/72/75Hz; 1024x768@60/70/75Hz;
1152x870@60HZ; 1280x960@60Hz; 1152x864@75Hz; 1280x720@60Hz;
1280x1024@60/75Hz; 1440x900@60Hz; 1600x1200@60Hz; 1680x1050@60Hz;
1920x1080@60Hz; 1920x1200@60Hz
If the resolution of your monitor is not included above, you must use the Self-EDID learning
feature of the transmitter unit to copy the EDID data from the monitor into the transmitter unit.
Self-EDID learning procedure
1. Power on the display.
2. Plug the 5VDC power adapter into the transmitter unit.
3. Connect the transmitter unit to the display/sink, not to the HDMI source.
4. Push the Self-EDID button with a narrow pin. The R/W LED will blink three times to
indicate the reading of EDID information. When the LED is totally turned off, the EDID
copying procedure is done.
Recovery of original EDID setting
Plug 5VDC power adapter into the transmitter and disconnect all other connectors.
Push the self-EDID button with a narrow pin. The R/W LED will blink six times to indicate the
recovery of EDID information. When the LED is totally turned off, the recovery procedure
is done.
Insert a narrow pin into this
hole to push the Self-EDID
button
When copying the EDID
information this LED will be
blinking 3 times
CAUTION!
The Extender will get very hot during operation!
Avoid touching it directly and install it with adequate ventilation!
