Lindy 32114, User Manual

Page: 3 / 12

User Manual English
Introduction
Thank you for purchasing the HDMI 2.0 EDID Emulator. This product has been designed to provide
trouble free, reliable operation. It benefits from both a LINDY 2 year warranty and free lifetime technical
support. To ensure correct use, please read this manual carefully and retain it for future reference.
This product is designed to help overcome EDID related problems which can occur when using AV/KVM
Extenders, Switches and Splitters. It can also be used in place of a monitor to keep a PC or Server
awake for remote access via IP.
Package Contents

HDMI 2.0 EDID Emulator

This Manual
Specification

Supports EDID learning or Preset Emulation

15 Pre-set EDID modes with blocks for AV and PC applications

Compatible with HDMI 2.0 Resolutions up to 4K 60Hz 4:4:4 8bit

Capable of supporting HDCP 2.2, 3D

Powered via HDMI source interface
Installation and Use
The EDID Emulator Adapter contains preset EDID information for many commonly used resolutions and
refresh rates, please refer to the table on the following page. To use the preset data select the correct
rotary dial position then skip to Step 8 of the Cloning Procedure.
Cloning Procedure
1.
In order to use your own EDID please turn the rotary dial on the unit to setting “0”
2. Connect a standard HDMI cable to the HDMI Input port of the display which you want to clone -
but do not connect it to the Emulator!
3. Insert the male HDMI connector of the Emulator into the HDMI Output port of your source device,
the Status LED will flash red for 5 seconds.
4. Whilst the Status LED is flashing red connect the other end of the HDMI cable from step two, the
Status LED will momentarily turn purple as is reads the EDID of the display.
5. When the Status LED switches from purple to blue the EDID has been learnt and stored to the
Emulator.
6. The Emulator can then be disconnected from the source/HDMI cable and installed as required,
please see the installation examples below for suggested positioning within an installation.
7. It is recommended that all equipment is power cycled, before the Emulator is used, to reinitiate
the HDMI handshake.
8. When installing the Emulator attach one end of a HDMI cable to the display/extender/switch and
then the other end to the Emulator. Finally connect the Emulator directly to the HDMI source
device.