background image

6.

Step 1: Place knee
under bottom dirt
canister to support
the weight of the
can, while you un-
latch it.

Step 2: Set the dirt can
on the floor.

Step 3: Remove edge of
the plastic bag from the
bag clip.

Step 4: Lift the plastic bag
from the dirt can.

Step 5: When plastic bag
is high enough, wrap up
the open end of the bag
for a mess-free dis-
posal.

Step 8: Throw away the
used plastic bag.

Step 6: Lift up the top
lid.

Step 7: Clean debris
from top screen as you
would a dryer lint screen
by wiping debris off of
screen and deposit de-
bris into used plastic
bag.

8.

7.

Air Channel

Bag Clip

4 Mill. Plastic Bag

Note: 

Note: 

Note: 

Note: 

Note: Do not store your replacement
plastic bags on top of your central
vacuum system.  This can cause
severe damage to your central vacuum
system by not allowing the motor to get
cool clean air.

Step 1: Place a clean
plastic bag into the
dirt can.

Step 2: Wrap the edges of
the plastic bag around the
edge of the dirt can.

Step 3: Place the portion
of the plastic bag around
the Air Channel under
the bag clip.

Step 4: Use your hands and
press the plastic bag up
against the sides of the dirt
can.

Step 5: Lift dirt can
back to the bottom
of  the dirt canister.
Use your knee to
support the can as
you re-latch it.

INST

INST

INST

INST

INSTALLA

ALLA

ALLA

ALLA

ALLATION OF NEW PLASTIC BA

TION OF NEW PLASTIC BA

TION OF NEW PLASTIC BA

TION OF NEW PLASTIC BA

TION OF NEW PLASTIC BAG

G

G

G

G

SOME  MODELS  WITH  SEPARATE

DIRT  CANISTER  ONLY

7

1.

2.

3.

5.

4.

SERVICING Y

SERVICING Y

SERVICING Y

SERVICING Y

SERVICING YOUR DIR

OUR DIR

OUR DIR

OUR DIR

OUR DIRT CAN WITH AIR CHANNEL

T CAN WITH AIR CHANNEL

T CAN WITH AIR CHANNEL

T CAN WITH AIR CHANNEL

T CAN WITH AIR CHANNEL

Inverted Bag Systems

Inverted Bag Systems

Inverted Bag Systems

Inverted Bag Systems

Inverted Bag Systems

Remove the dirt canister by supporting the bottom canister with your knee*.
Then, unsnap the two dirt canister latches by grasping the lower end of each
latch and pulling straight away from the canister (see figure 1c).

1

IIIIInverted bag units provide a permanent filter and require occasional cleaning.  To clean the inverted

bag units, follow these steps:

Carefully lower the dirt canister, dump the contents into trash container
(figure 2c), and then set aside.

2

It is not necessary to remove the inverted bag to clean.  A plastic bag may be
placed over the bottom portion of the top canister.  Then, while holding the
plastic bag tightly around the canister with one hand, push the bag up inside
with the other hand, and brush/shake the bag surface to loosen any dust and
debris that may have accumulated on the bag (see figure 3c).  In this way, the
bag can be cleaned without getting any dust or debris on the floor or hands.

3

4

Replace the dirt canister by slipping the rim of the dirt canister over the lip of the
top can until it is seated against the rim gasket.  Then while holding the canister
in place with your knee* (see Figure 1c) fasten the two latches.  Do this by hooking
the top lip of each latch over the rim of the top can and then press straight in on
the bottom of the latches until they lock.

Initially, the dirt canister should be checked or emptied weekly until some idea can be obtained as to

HOW OFTEN SHOULD I CHECK OR EMPTY MY DIRT CANISTER?

?

how long it takes to half fill the canister under your normal cleaning routine.   All   vacuum   systems   will   function
more effectively if it is emptied frequently.  Under no circumstances should you allow your dirt canister to become
more than 3/4 full before emptying. (Note: The canister will fill more rapidly if NEW carpets are being cleaned
for there is usually a tremendous quantity of loose fibers that are retained in the carpet from the manufacturing
process.  In some instances   it   may   take   several   months before all of these loose fibers are removed.)

*If you have trouble removing or replacing the dirt canister using your knee, try supporting the can with one hand, unlatching (or relatching)
one side with the other hand.  Then, reverse your hands to unlatch (or relatch) the other side.

Figure 1c

Figure 1c

Figure 1c

Figure 1c

Figure 1c

Figure 3c

Figure 3c

Figure 3c

Figure 3c

Figure 3c

HOW OFTEN SHOULD I CLEAN THE INVERTED BAG?

The inverted bag should be cleaned approximately 3-4 times a year or every time the dirt canister is dumped.  If
your inverted bag should ever need replaced, contact your local dealer.

8

Figure 2c

Figure 2c

Figure 2c

Figure 2c

Figure 2c

Summary of Contents for VacuMaid

















Reviews: