Lindsay Transportation Solutions Sales and Services, Inc
(888) 800-3691 [U.S. toll free] or +1 (707) 374-6800
Lindsay Transportation Solutions Sales and Services, Inc
(888) 800-3691 [U.S. toll free] or +1 (707) 374-6800
18
Page 18
U n i v e r s a l T A U - I I
®
C r a s h C u s h i o n
P A R A L L E L S Y S T E M
Step 8.
Attach the Nose Cover and left Slider Panel to the
Front Support. Install the bushing in the hole of the
nose piece. Install the fender washer on the machine
bolt (Slider Bolt not used) and push the bolt through
the bushing in the Nose Cover hole. Continue the
bolt through the hole in the front edge of the last-bay
Slider Panel and finally push the bolt through the hole
in the Front Diaphragm. Install the washer and hand
tighten the nut. (The nut will be tightened later.) Use
Nose Piece Hardware Kit #K001013.
Repeat the process outlined in Step 8 with the right
side of the assembly.
The final step in the assembly of the nose bay is to
install the Support Legs. Place the nose assembly on
its side. Push one of the leg support machine bolts
and washer through the hole in the bottom rail of the
Front Support. Screw the Leg Support onto the bolt
and tighten the bolt with a wrench or socket.
Warning: DO NOT OVER-TIGHTEN THIS BOLT.
Use the Front Support Leg Hardware Kit #K001005.
Carry the complete nose bay assembly to the front of
the system. Attach the Slider Panels to the
diaphragm by pushing the Slider Bolt through the
slots in the final bay Slider Panels and then through
the hole in the front of next bay Slider Panel. Finally,
push the Slider Bolt through the hole in the side of the
Diaphragm and attach the flat washer and nut.
Repeat with the right side
Front View of Assembled Nose Assembly Rear View
Bolt the Support Legs to the bottom of the Front Support Assembly.
Carry the assembled Front Support Assembly into position to attach.
Attach Nose Cover and Slider Panel to Front Support
The solid plate on Front Assembly must
be on the bottom and facing the front