Lindsay Transportation Solutions Sales and Services, Inc
(888) 800-3691 [U.S. toll free] or +1 (707) 374-6800
Lindsay Transportation Solutions Sales and Services, Inc
(888) 800-3691 [U.S. toll free] or +1 (707) 374-6800
16
Page 16
U n i v e r s a l T A U - I I
®
C r a s h C u s h i o n
P A R A L L E L S Y S T E M
Step 7.
At this point you will start assembling the sides of the
system. The first two side panels are installed
together as the Sliding Bolt attaches both of the
panels to the Pipe Panel Mount located on the side of
the Backstop Diaphragm. Attach the right side End
Panel and right side rear-most Sliding Panel to the
Pipe Panel Mount using the Sliding Bolt.
Insert the Slider Bolt through the slotted portion of the
last bay Sliding Panel. Continue the bolt through the
front hole of the End Panel. Continue the bolt
through the bolt hole in the outside of the Pipe Panel
Mount as shown in the photo above.
NOTE: For the system to telescope properly, the
slotted Sliding Panel MUST be on the outside of
the End Panel.
The photo above shows the end of the Slider Bolt
coming through (from the outside) the slot in the last
left bay side Sliding Panel, through the front hole of
the End Panel and through the outer hole of the Pipe
Panel Mount.
NOTE: For ease in assembly of the rest of the
system, hand tighten the nut on the Slider Bolts. The
bolts will be tightened in a later step. Use Slider Bolt
Hardware Kit #K001003.
You will now attach the right side panels one-by-one,
moving towards the front of the system. Attach the
rear bay and second-to-last bay Sliding Panels to the
first diaphragm using Sliding Bolts. Insert the Sliding
Bolt through the slot in the second-to-last bay Sliding
Panel. Continue pushing the bolt through the hole in
the front of the last Sliding Panel and finally push the
bolt through the hole in the side of the corresponding
Diaphragm.
NOTE: For the system to telescope properly, the
forward most slotted Sliding Panel MUST be on
the outside.
View from outside showing the End Panel and Sliding Panel attached with the
Slider Bolt.
Sliding Panel
End Panel
Sliding Bolts
Install the End Panel and the last bay Sliding Panel together
Front of
Backstop
Diaphragm
Last Bay
Sliding Panel
End Panel
The Slider Bolt holds on the (last bay) Slider Panel and End Panel
Sliding Panel
On outside
End Panel
Sliding Bolts
Pipe Panel Mounts
Front of Backstop
Diaphragm
Install each of the Sliding Panels
NOTE: See configuration chart to determine if you
have “stacked” or “nested” slider panels in some
locations.
