•
The LB-TFPS-180-540-90UI power supply is factory assembled at 6 Amp
maximum on the output port. The output port has a T8.0A fuse.
•
System reliability depends on protecting the power supply from
overcurrent events. Through proper fuse selection, you can minimize
risks and failures.
•
Verify current draw on each output port. Pick a slow-blow fuse 130%
higher than output port current draw. (ie. Output port has 3A current
draw; 3A + 130% = 3.9A, replace 8A fuse with a 4A fuse).
•
Insure that the output load does not exceed 6 Amps.
Installation and Operation:
9
•
Adjusting the maximum output current:
•
Remove front Panel of power supply
•
Locate Dip Switches; Dip switches are on the right hand side of
the main PC board.
Figure 10: DIP Switch Location
