LINDR VCH 02237 AS-200-us, Manual

Page: 22 / 28

22
22. Table of defects:
MALFUNCTION CAUSE REMOVAL
The device does not work.
Power cable is not
plugged in.
Plug in the cable.
Main switch off
Turn on the main switch.
is off.
The thermostat is set to "0". Set the thermostat to the desired value.
No water in the tank. Pour water into the tank.
The device does not cool to the
set temperature.
incorrect thermostat setting.
Turn the thermostat knob
to the right towards number 7.
Poor air circulation.
Check the cleanliness of condenser
plates.
The air vents are obstructed. Free up the air vents.
The device overheats.
Place the device in a colder environment.
Rapid couplings are leaking. Hose poorly inserted.
Pull out the hose, check that the end of
the hose is flat (not at an angle), level off
with a knife if needed.
Scratches on the hose. Pull out the hose and shorten it by ca. 2
cm.
NOTE: If the defect persists even after the above steps are taken, contact a service
centre.