5.
1.
2.
5.
6.
2.
3.
8.
8.
7.
3.
4.
4.
1. Beverage
inlet
2. Keg coupler (S-type, A-type,
M-type)
3.
Plastic fitting
F 5/8 x9.5mm
4.
Plastic fitting
F 5/8 x 8 mm
5.
Plastic fitting
Y 8x8x8mm
6.
Pressure
reducer
CO2
7. Plastic fitting
F 7/16 x 8mm
8. Beverage
Connection D: using a machine with two dispensing taps together
with a CO2 bottle.
Other options of pressurizing:
By compressor PUMA 1HP a 1/2HP, compressor LEONARDO 1HP, compressor AIRCRAFT 1HP or with N2 bottle.
1.
2. CO2 o
utlet
3. Pressure Control
4. Keg coupler (S-type, A-type,
M-type))
5.
Plastic fitting
F 5/8 x9.5mm
6.
Plastic fitting
F 5/8 x 8 mm
7. High pressure hose with a
sleeve nut
W 21.8
for the
cylinder with thread
G3/4
is
needed to use the adapter for
K 115 / R.
8.
Beverage
Beverage inlet
1.
2.
4.
4.
6.
6.
5.
5.
7.
8.
8.
1. Screw the plastic fittings onto the keg coupler (see picture 5 and 6 / page 9).
2. Insert the hose 3 / 8 and 5 / 16 into the the plastic fittings on the keg coupler (see picture 8 and 9 / page 9).
3. Connect the hose 3 / 8 and 5 / 16 with the plastic fittings placed on the cooling machine according to the descrip-
tion on the label. The label is located above the fittings.
4. Attach the high pressure hose to the C02 bottle using a cap nut (No. 7).
5. Put the coupler on the beverage keg and make sure the coupler is in the closed position (upper position).
6. Open the shut-off valve on the CO2 bottle and set the desired pressure for both lines using the srews on the top of
the machine (No.3). (The pressure setting is displayed on the manometer on the front side of the cooling machine).
7. Connect the keg using the keg coupler.
ENGLISH
Connection E: CONTACT 115R for use to pressurize the traditional CO2 bottle (or mixed gas of CO2
and N2 - reduction)
(machine with two dispensing taps)
Connection and regulation of CONTACT 115 / R to CO2 bottle
3.
