User guideline NORTEC sonic
NRSB-09
Issued by: PM Floor Division
10.6.09
Page 3 of 6
Rev.00
NRBS-09
NORTEC sonic with visible perforation
Place the lifting device in a ventilation hole in
the centre of the panel edge and lift the panel
slightly to loosen it and then remove the lifting
device again.
Then place the lifting device in a ventilation
hole at the middle of the outer edge on the left
and right side of the panel and lift it vertically.
2.2 Inserting of panel
NORTEC sonic with covered perforation (textile covering)
Place the lifting device on one side, hold the
panel with your hands, lay it with one side on two
pedestals and push it to the neighbouring panel.
Lower the panel with the lifting device. If with the
use of a velour covering, the first row of the piles
of the adjacent panel is pinched in, the proper,
original state can be restored by “lifting” the
inserted panel a bit.
