Linden L49UTV17a, Instruction Manual

Page: 16 / 52

14
Basic Set Up
1.
Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the
TV slightly overhangs on it. Please make sure a soft cushioned material (such as a pillow or thick piece of foam) is placed
beneath the screen.
Installing the Base Stand
Slide the stand under the bottom of the TV. The stand will fit snugly over the screw holes. Then screw the stand to the TV by
using screws supplied.
• The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be
sure that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it.
DO NOT exert pressure on the front of the TV at any time because the screen could crack.
• It is recommended that two people take part in the base installation.
1. To remove the stand assembly, untighten the screws holding the stand assembly at the rear of the TV. Remove the stand
assembly.
• Remove the stand assembly before mounting the TV onto the wall.
• It is recommended that two people take part in the installation.
Keep all the spare screws
should you want to use the
stand assembly option.
Mounting the TV to a Wall
• Please read this instruction manual carefully while setting up your TV.
• If you require additional assistance, please call our customer care center on
1300 530 800 .