Linde T 16, Operating Instructions Manual

Page: 40 / 53

3
6
0
8
0
4
2
5
1
1
-
0
5
0
4
Maintenance Maintenance every 500 hours
Inspection / replacement of the traction
motor brushes
- Disconnect the battery connector.
- Remove the front cover.
- Pull the plastic covers (1) clear.
- Remove the motor protection screen (2).
- Clean the motor using compressed air.
- Check that there are no traces of overheating on the brush
connections.
- Check the tightness of the connections.
- Check that the brushes move freely in their channels by
pulling gently on their shunts.
- Lift the springs, withdraw the brushes and their guides
(2), and measure their length.
- Replace if necessary.
- Check that the commutator is not scored, and shows no
signs of sparking.
NOTE
Always replace brushes as a complete set.
We recommend leaving this operation to your local
representative.
Dimensions:
Drive motor:
0,7 kW neuf : 25 mm
mini : 15 mm
0,9 kW neuf : 25 mm
mini : 15 mm
1,2 kW neuf : 32 mm
mini : 15 mm
ATTENTION
In the event of any anomaly, please contact your
local representative.
Checking miscellaneous joints
- Inspect and lubricate the various pivots:
- Use oil or an aerosol lubricant.
https://www.besttruckmanuals.com/