Linde T 16, Operating Instructions Manual

Page: 27 / 53

3
6
0
8
0
4
2
5
1
1
-
0
5
0
4
ATTENTION
Take care not to disturb any adjacent loads, or
those which may be to the side or in front of the
load being handled.
Loads should be laid out as follows:
- Line up loads with a small space between each one and
its neighbour in order to avoid any fouling.
ATTENTION
Before lifting a load, ensure that its weight does
not exceed the truck’s capacity.
- Refer to the nominal capacity marked on the truck’s plate.
- Ensure that the load is stable and uniform in order to
prevent any partial spillage.
- Check that the width of the load is compatible with the
width of the forks.
Transporting the load
- Always carry loads in the forward direction of travel in
order to have the best visibility.
- When carrying a load on a slope, always ascend or
descend with the load up-slope. Never drive laterally
across a slope or perform a U-turn.
- Reverse travel is to be used solely for unloading. Since
visibility is reduced when travelling in this direction, drive
only at very slow speed.
Loading
- Carefully approach the load
- Adjust the height of the fork arms until they can be easily
inserted into the pallet
- Insert the forks beneath the load
- If the load is shorter than the forks, position the forks so
that the front of the load overhangs them by several
centimetres, in order to avoid any interference with the
load immediately ahead
- Lift the load a few centimetres from its support
- Back the truck away from the pallet holder or any
neighbouring loads, gently and in a straight line.
- Lower the forks until the load is a few centimetres from
the ground.
Load handing Use
https://www.besttruckmanuals.com/