18
l i n d a b | we s i m p l i f y c o n s t r u c t i o n
Vertical obstacles
If you encounter vertical water pipes, make a hole
measuring about 80×30 mm in the panel that bypasses
the pipes. Fit a divisible rubber washer to the surface of
the panel to hide the hole and create a neat installation.
When an electrical cable is routed vertically on the wall,
leave a hole in the wall rail that is 6 mm larger than
the diameter of the cable. Seal around the cable using
elastic sealant.
Touch-up paint
If the finish of the panels was damaged during
installation, you can use touch-up paint to con-
ceal the damage.
Rail alignment plate
If two rails don’t align properly it is recommended to place a rail alignment plate inside the
two rails where they meet to make them to align.
