8
5
SERVICING YOUR POOLCLEANER
(Changing tyres on your PoolCleaner™)
BEFORE YOU DO ANYTHING, TURN THE PUMP
OFF
. SUCTION CAN BE DANGEROUS!
1.
Remove the PoolCleaner™ from the pool, making sure to place
the hoses straight.
Seperate the PoolCleaner™ from the Leader Hose.
2. The tyres
must
be replaced when the tyres are worn down
to the tread wear indicators!
3. Place the cleaner on a work surface. To remove
the 2X PoolCleaner™ tyres, using only your hands
(other objects may damage the PoolCleaner™)
simply fold the tyre off from top to bottom.
4. Place the Shroud back onto the
PoolCleaner™ making sure it’s on
correctly. Drop the three screws into
the screw holes and secure.
PREPARING YOUR SKIMMER
NOTE: Failure to remove air bubbles in the Filters can induce an airlock into the
plumbing system, this will cause the pump and heater to operate incorrectly. To ensure
there are no airlocks, simply loosen the barrel unions to the pump and heater to release
any trapped air and then re-tighten (when conducting this procedure, ensure the Spa
Power is OFF).
2
3
4
2
3
4
5
FRONT
LOAD
TOP
LOAD
TOP
LOAD
FRONT
LOAD
REPLACE CARTRIDGES WITH VACUUM FITTINGS
HOW TO REMOVE FILTER CARTRIDGES
1.
Make sure Spa Power is off.
2. TOP LOAD: Remove Skimmer
lid by pulling up vertically.
FRONT LOAD: Remove Skimmer
face by pulling up vertically.
3. FRONT LOAD: Remove Leaf Tray by sliding out
forwards.
4. TOP LOAD: Unscrew Filter Cartridges
by rotating anti-clockwise.
FRONT LOAD: Unscrew Filter Cartridges
by rotating anti-clockwise and lift up
and pull out of filter box.
5. Submerge vacuum fittings into the spa
first to remove trapped air bubbles prior to
inserting Vacuum Fittings into Skimmer box.
6. Install Vacuum Fittings by rotating
clockwise, making sure not to over tighten.
7. Connect elbow or hose adaptor to open end
of vacuum fitting.
8. TOP LOAD: Replace Skimmer lid by locating
into the recess and push down until
it clicks into place.
FRONT LOAD: Leave the Leaf Tray
and the Skimmer Face off.
9. Power on Spa and run
Spa in Filter Cycles.
