Lincoln LS 2000, Owner'S Manual

Page: 128 / 272

attaching hardware, should be inspected after a collision. Ford
recommends that all safety belt assemblies used in vehicles involved in a
collision be replaced. However, if the collision was minor and a qualified
technician finds that the belts do not show damage and continue to
operate properly, they do not need to be replaced. Safety belt assemblies
not in use during a collision should also be inspected and replaced if
either damage or improper operation is noted.
Failure to inspect and if necessary replace the safety belt
assembly under the above conditions could result in severe
personal injuries in the event of a collision.
Refer to Cleaning and maintaining the safety belts in the
Maintenance and care section.
AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
Your vehicle is equipped with a crash sensing and diagnostic module
which records information about the air bag and sensor systems. In the
event of a collision this module may save information related to the
collision including information about the air bag system and impact
severity. This information will assist Ford in the servicing of your vehicle
and may help Ford better understand rear world collisions and further
improve the safety of future vehicles.
PULL
AUTO
RESUME
SET
CANCEL
O
N
O
F
F
MUTE
VOL
MEDIA
HI
LO
INT
INT
OFF
MIST
P !
BRAKE
H
C
1
2
3
4
5
6
7
0
0
20
40
60
80
100
120
140
160
40
80
120
160
200
240
km/h RPMX1000
RESET
MPH
F
E
SEEK MUTE
VOL
PUSH ON
CD TAPE
EJ
BASS
TREB
SEL
BAL
FADE
TUNE SCAN AUTO
AM
FM
REW
1
FF
2
SIDE 1-2
3
COMP
5
SHUFF
6
4
RDS
AUTO OFF
A/C
R
EXT
F C
F F
Seating and safety restraints
128