4. For memory recall feature, enter the sixth digit 1
•
2 to store driver 1
settings or 3
•
4 to store driver 2 settings.
Note:
Touching 5
•
6, 7
•
8, or 9
•
0 keypad numbers as a sixth digit
will not recall a driver memory setting.
Note:
The factory-set code cannot be associated with a memory setting.
5. The doors will lock then unlock to confirm that your personal entry
code has been programmed to the module.
Tips:
•
Do not set a code that uses five of the same number.
•
Do not use five numbers in sequential order.
•
The factory set code will work even if you have set your own personal
code.
Erasing personal code
1. Enter the factory set 5–digit code.
2. Within five seconds, press the 1
•
2 on the keypad and release.
3. Press and hold the 1
•
2 for two seconds. This must be done within
five seconds of completing Step 2.
All personal codes are now erased and only the factory set 5–digit code
will work.
Anti-scan feature
If the wrong code has been entered seven times (35 consecutive button
presses), the keypad will go into an anti-scan mode. This mode disables
the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
•
one minute of keypad inactivity.
•
pressing the
control on your transmitter.
•
the ignition is turned on.
•
the door is unlocked with a key
Unlocking and locking the doors using keyless entry
To unlock the driver’s door,
enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate.
Note:
If the two-stage unlocking
feature is disabled, all doors will unlock; for more information regarding
Locks and Security
120
2011 MKS
(mks)
Owners Guide, 1st Printing
USA
(fus)
