After completing the “Programming” functions, follow these steps to
train a garage door opener with the rolling code feature:
1. Locate the
training button
on the garage door motor head unit.
Refer to the garage door opener manual or call 1–800–355–3515 or on
the Internet at
HomeLink.jci.com.
if there is difficulty locating the
training button.
2. Press the training button on the garage door motor head unit (which
will activate the
“training” light
).
3. Press and release the
programmed HomeLink
t
button.
Press and release the HomeLink
t
button a
second time
to complete
the training process. (Some garage
door openers may require this
procedure to be done a third time
to complete the training).
The 2nd or 3rd press from step 3 will activate the door. The HomeLink
t
Universal Transceiver has now been trained to the receiver. The
remaining two buttons may now be programmed if this has not
previously been done.
Erasing HomeLink
T
buttons
Individual buttons cannot be erased,
however, to erase the three
programmed buttons:
1. Hold down the two outside
buttons until the red light begins to
flash after 20 seconds.
2. Release both buttons.
Reprogramming a single HomeLink
T
button
To program a device to HomeLink
t
using a HomeLink
t
button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
t
button.
Do NOT
release until
step 4
has been completed.
Controls and features
89