A-5
INSTALLATION
VANTAGE
®
435X
BATTERY CONNECTION
Use caution as the electrolyte is a strong acid that can burn
skin and damage eyes.
The Vantage
®
435X is shipped with the negative battery cable
disconnected. Make certain that the RUN/STOP/IDLE switch is in
the STOP position. Remove the four screws from the battery tray
using a screwdriver or a 3/8"(10mm) socket. Attach the negative
battery cable to the negative battery terminal and tighten using a
1/2"(13mm) socket or wrench.
NOTE: This machine is furnished with a wet charged battery; if
unused for several months, the battery may require a booster
charge. Be careful to charge the battery with the correct polarity.
(See Battery in MAINTENANCE section)
GASES FROM BATTERY can
explode.
•
Keep sparks, flame and cigarettes away
from battery.
To prevent EXPLOSION when:
•
INSTALLING A NEW BATTERY — disconnect negative
cable from old battery first and connect to new
battery last.
•
CONNECTING A BATTERY CHARGER — remove
battery from welder by disconnecting negative cable
first, then positive cable and battery clamp. When
reinstalling, connect negative cable last. Keep well
ventilated.
•
USING A BOOSTER — connect positive lead to battery
first then connect negative lead to negative battery lead
at engine foot.
BATTERY ACID can burn eyes and skin.
• Wear gloves and eye protection and be careful
when working near battery.
• Follow instructions printed on battery.
IMPORTANT
: To prevent ELECTRICAL DAMAGE WHEN:
a) Installing new batteries.
b) Using a booster.
Use correct polarity —
Negative Ground.
EXHAUST OUTLET PIPE
Remove cap from DOC pipe protruding from roof.
Using the clamp provided secure the outlet pipe to the outlet tube
with the pipe positioned such that it will direct the exhaust in the
desired direction away from the air intake. Tighten using an
internal socket or allen wrench.
SPARK ARRESTOR
Some federal, state or local laws may require that gasoline or
diesel engines be equipped with exhaust spark arrestors when
they are operated in certain locations where unarrested sparks
may present a fire hazard.
The DOC (Diesel Oxidation Catalyst) unit included with this welder
does not qualify as a spark arrestor. When required by local
regulations, a suitable spark arrestor must be installed and
properly maintained.
An incorrect spark arrestor may lead to damage to the
engine or adversely affect performance.
AIR CLEANER INSTALL
All parts below are shipped with the machine in a separate box
attached to the crate. (see Figure A.2)
• Remove cap from air intake hose and DOC exhaust attached on
machine. Insert air cleaner into bracket between the two ridges
of a larger diameter. Position the vacuator 6 o’clock.
• Tighten air hose clamp just below service indicator to hold
clamp while pushing air cleaner onto hose, once hose is in
place loosen air hose clamp slide down and tighten clamp.
• Install 2 hex head screws, washers and nuts to mounting
bracket securing air cleaner.
• Install Inlet Hood to Air Cleaner, tighten clamp securely.
SERVICE INDICATOR
Air cleaner service indicator provides a Go/No-Go visual indication
of useful filter service life.
FIGURE A.2
CAUTION
WARNING
WARNING
MOUNTING BRACKET
VACUATOR VALVE
INLET HOOD
EXHAUST OUTLET
CLAMP
(5/16-18x 1.25 HHCS) (2)
(LOCK WASHER) (2)
(MAIN WASHER) (2)
SERVICE INDICATOR
AIR HOSE CLAMP