Spirit II User’s Manual
Section 3: Installation
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
3-1
Section 3: Installation
Initial Inspection
All systems undergo full testing before being shipped from the factory. In the unlikely
event that one of the components is defective or missing, please contact customer
service so that a replacement can be sent. Also, special care has been taken in the
packaging of the system. If the system was damaged during shipment, file a claim with
the shipping company, and then contact customer service to order the necessary parts.
Component Placement
Plasma Power Supply
The power supply should be lifted by a forklift, pallet jack or crane. In order to prevent
damaging the power supply when lifting with a forklift or pallet jack, the forks should be
of adequate length to protrude on the far side of the power supply. If lifting with a sling
(lifting straps), ensure the following:
•
Sling and material handling equipment must comply with local and national laws
and regulations. The personnel involved in the move must be properly trained
and qualified to use such equipment.
•
All power supply covers must be securely installed.
•
Two slings are required. Each sling should pass through all three (3) structural
members on the bottom of the power supply. See sling access holes below.
•
Lift slowly -not more than 8 in. (203 mm) high- to ensure even weight distribution.
•
Move slowly to prevent uncontrollable acceleration/deceleration.
WARNING
Falling equipment can
cause injury.
•
Lift only with
equipment of
adequate lifting
capacity.
•
Be sure power
supply is stable
when lifting.
The proper location of the power supply will provide dependable service and reduce
periodic maintenance time. Choose a location that will provide unrestricted air
movement into and out of the power supply. Maintain
at least 24 inches
of space on
all
sides of the unit. The location should subject the power supply to the least amount
of dust, dirt, moisture, and corrosive vapors. The surface on which the power supply is
located should have a grade of no greater than 10º to eliminate the risk of toppling over.
Sling
Access
Hole
