C - DESCRIPTION OF ASSEMBLING IN PLASMA CUTTING PROCESS
8695 4598 / G
C-50
CPM 400-450-600wi
Put the upstream nozzle (M62) in the torch tip, after selecting it according to the cutting table, and
lubricate it above the outer diameter.
Put the internal water vortex kit,
CPM600
wi
(M63) with or without the downstream nozzle (M65)
(according to the cutting table) so that it presses against the nozzle (M62). The seals need not be
lubricated.
Take the cap (M64) and slightly lubricate the metal part located above the tap over approximately 1 cm
on the top of the blue insulating sleeve.
Screw the cap on the tip, holding the rapid torch nut with one hand, with its snugs engaged on the flats
of the tip shaft.
