–
19
–
POWER SOURCE OPERATION
Duty Cycle and Time Period
The CV-400 is rated at the following duty cycles:
Duty Cycle* Amps Volts
100% 400 36
60% 450 38
50% 500 40
* Based upon a 10 minute time period. (i.e., for 60%
duty cycle, it is 6 minutes on and 4 minutes off).
Overloading the power source may result in opening
of an internal protective thermostat as indicated by the
amber thermal protection light turning on.
STARTING THE MACHINE
The POWER toggle switch at the extreme right side of
the control panel in the “
I
“ position energizes and
closes the three phase input contactor from a 115 volt
auxiliary transformer. This in turn energizes the main
power transformer.
The machine is de-energized when the POWER
switch is in the “
0
” position.
The white light next to the POWER switch indicates
when the input contactor is energized.
OUTPUT VOLTAGE CONTROL DIAL
The Output control dial at the right of the control panel
is a continuous control of the machine output voltage.
The control may be rotated between minimum and
maximum to adjust the machine output, even while
welding.
The machine is equipped with line voltage compensa-
tion as a standard feature. This will hold the output
constant except at maximum output of the machine,
through a fluctuation of ±10% input line voltage.
OPERATING INSTRUCTIONS
Safety Precautions
When using a CV-400 power source with wire feeders,
there will be a small spark if the electrode contacts the
work or ground within several seconds after releasing
the trigger.
When used with some wire feeders with the electrical
trigger interlock in the On position, the arc can restart
if the electrode touches the work or ground during
these several seconds.
ELECTRIC SHOCK
can kill.
• Have an electrician install and service
this equipment.
• Turn the input power off at the fuse
box before working on equipment.
• Do not touch electrically hot parts.
• This next section applies to CV-400’s without the
Capacitor Discharge Option:
---------------------------------------------------------------------
WARNING
Summary of Contents for IDEALARC CV-305
Page 29: ...CV400 NOTES...
Page 30: ...CV400 NOTES...
