Lincoln Electric FLEXCUT 125 CE, Safety Instruction For Use And Maintenance

Page: 35 / 44

8695 4496 / B
F - MAINTENANCE
FLEXCUT 125 CE INSTALLATION
F-31
2.4 Other faults
Fault Probable causes Possible remedies
The tool-holder does not move
The torch has not been selected
Lower limit switch (UI alarm)
Probe impact (UI alarm)
Upper limit switch (no alarm)
Select the torch manually
Correct the fault and set the tool
holder position if required.
Correct the fault and clear the
alarm
Correct the fault and set the tool
holder position if required.
Two torches cannot be selected
The two torches are not identical
(type)
Select two identical torches
Cutting cannot be started
Lack of extraction or ineffective
extraction Start/clean the extraction before
cutting
Cutting is not correct Several possible causes.
Refer to the process training
manual
Incorrect cutting height
The tool holder speed offset has
not been set.
The plate is not on fixed supports
Set the speed offset of the
variable speed drive
Reposition the plate or change
the detection method (using pilot
arc)