Lincoln Electric FLEXCUT 125 CE, Safety Instruction For Use And Maintenance

Page: 31 / 44

8695 4496 / B
FLEXCUT 125 CE INSTALLATION
F-27
F - MAINTENANCE
1 - SERVICING

So that the machine continues to provide good service for as long as possible, a certain minimum of care and
maintenance is necessary

The frequency of this maintenance work is given on the basis of the production of one work station per day.
Maintenance should be more frequent if production is greater.

For the maintenance of the
Flexcut 125 CE
power source, please refer to instructions IM10375.

For the maintenance of the tool holder
PO150D
, please refer to instructions 8695 4566.
Your maintenance department may photocopy these pages so that it can follow up maintenance dates and
operations (tick as appropriate)
Monthly
Date of maintenance : / /
- Check that the gas circuit operates properly: pressure gauge, pressure regulator, electrovalve,
valve, couplings, etc.
Note : any piping showing the slightest signs of fatigue, wear, damage, should be replaced by a
standard identical pipe.
- Check the condition of all the electrical cables, especially near the torches and in the cable
support chain (change them if required). Check that electrical wires are tightened.